汽油钻孔取芯机操作说明操作说明: 1.先根据现场情况和钻孔位置固定好机身,并检查是否牢靠: ①支撑顶杆:将钻机放到钻孔位置,用四个调平螺栓将钻机调平,然后用一根长度合适的钢管顶至屋顶,旋转顶丝至手感稳固即可。 ②膨胀螺栓:在底座的开孔位置预设2个膨胀螺栓固定钻机,用四个调平螺栓将钻机调平,然后用膨胀螺栓紧固。 2.按钻孔直径选用钻头,并在螺纹部位涂上润滑脂后旋紧在钻机主轴上。 3.接通自来水管或水泵,打开给水阀门,并确认给水充足。 4.接好地线,与钻机插头相接的三芯电源插座地线必须与配电箱地线可靠连接。 5.接通电源,打开开关,空载启动,检查钻机运转是否正常,有无杂音,检查钻头是否跳动。确定一切正常后,方可钻孔。
汽油钻孔取芯机操作说明技术参数: 1、型号:HZ-20型 2、钻孔取芯直径:Φ300mm 可加大 3、钻孔取芯深度:700mm 可加大 4、钻孔方向:垂直向下 5、进给方式:手动、自动 6、主轴转速:800-1200 7、钻头形式:人造金刚石薄壁钻头 8、配套动力:汽油机 (本田) 9、功 率:5.5马力 9马力 13马力 我公司把顾客放在位,建立起了产品售、售中、售后服务规范,满足顾客要求,使我们的产品和服务深得顾客的信赖,与顾客建立起了长期合作和互利关系。 公司秉承“视售后服务为产品质量的延伸,视产品质量为企业生命”的宗旨,在网络化的售后服务管理体系的保障下,为用户提供优质的产品和服务。 我们热忱期盼与各位业内人士携手并进、共创未来! Our company puts the customer first, establishes the product pre-sale, sale, after-sale service standard, satisfies the customer request, causes our product and the service to win the customer's trust deeply, has established the long-term cooperation and the mutual benefit relations with the customer. The company adheres to the principle of "regard after-sales service as the extension of product quality, regard product quality as the life of the enterprise" , and provide high-quality products and services for users under the protection of the network The Adjuster management system. We sincerely look forward to working with you to advance hand in hand and create the future! 汽油钻孔取芯机操作说明 原创作者:河北献县鹏翼建筑仪器厂 |